top of page

LED SPOTLIGHTS

9 Inch Anti-Glare Driving Light, Osram P8 LED Chips, High/Low Beam, White/Amber Chasing DRL, 3-Pin DT Connector, Edgeless Design, 24-Month Warranty, Pair, Wiring Harness Not Included

Product Overview

The SpectrumTek Focus FZ-10 is a 9-inch edgeless LED driving light pair built to solve the biggest complaint with traditional auxiliary lights: glare. A redesigned anti-glare lamp cup with larger, deeper reflectors puts the light on the road and trail ahead. That gives you reach without scattering light back into your own eyes or into the eyes of oncoming drivers.

​

Each pair uses high-intensity Osram P8 LED chips and delivers 18,240 actual lumens on high beam and 8,640 on low beam, with a stable 114W draw on high beam. A built-in high/low beam system lets you use the full 680-metre reach on forest tracks and open roads, then drop to a more controlled 470-metre pattern in built-up areas. A 3D-structured signal light with white and amber chasing effects adds daytime visibility. An ADC12 die-cast aluminium housing and IP68/IP69K sealing keep out mud, dust and high-pressure water, and every pair is covered by a 24-month warranty.

​

The Focus FZ-10 is supplied as a pair with 3-pin DT connectors. The wiring harness is not included.

Key Features

  • Osram P8 LED chips: six high-intensity 20W chips per light for stable output, colour consistency and long service life

  • Anti-glare lamp cup: redesigned, larger and deeper reflectors reduce glare while extending reach

  • Edgeless design: a clean, seamless front with no bulky bezel, for a modern look on any vehicle

  • High/low beam in one light: switch between long-range driving beam and a more controlled low beam

  • 18,240 actual lumens (high) / 8,640 actual lumens (low) per pair: measured output published alongside the 26,400lm theoretical figure

  • 680m / 470m reach to 1 lux: high-beam and low-beam distances

  • 5700–6000K white light: clear, natural daylight colour that is easier on the eye over long drives

  • White and amber chasing DRL: a 10W white daytime running light and a 10W amber position light with a dynamic flowing effect

  • 3D signal light structure: improves visibility to other road users while driving and parking

  • ADC12 die-cast aluminium housing: strong, lightweight and good at drawing heat away from the LEDs

  • IP68 / IP69K sealing: protected against dust, immersion and high-pressure washdown

  • 9–32V DC input: works on 12V and 24V systems

  • Built-in electrical protection: over-voltage, polarity reversal and short circuit protection

  • Vibration resistant: built for corrugated tracks, farm work and heavy use

  • 3-pin DT connector: a secure, weatherproof, widely used connector

  • CE conformity and EMC certified

  • 24-month warranty: two years of cover for peace of mind

  • Wiring harness not included: choose a harness to suit your install (see the protection chart)

Technical Specifications

Specification
Details
Manufacturer
SpectrumTek (UK)
Model
Focus FZ-10
Size
9 inch
Dimensions
223mm x 233mm x 100mm
Design
Edgeless
LED technology
6x 20W Osram P8 high-intensity chips per light
Beam pattern
Anti-glare driving beam, high/low beam
LED power
120W (pair)
Actual power (high / low)
114W / 54W (pair)
Theoretical lumens
26,400lm (pair)
Actual lumens (high / low)
18,240lm / 8,640lm (pair)
Reach (1 lux)
680m (high) / 470m (low)
Colour temperature
5700–6000K
White DRL
10W, chasing effect
Amber position light
10W, chasing effect
Operating voltage
9–32V DC (12V and 24V compatible)
Housing
ADC12 die-cast aluminium
Mounting bracket
Stainless steel
Lens
Clear, impact-resistant polycarbonate (PC)
Waterproof rating
IP68 / IP69K
Operating temperature
-40°C to +85°C
Connector
3-pin DT connector
Wiring harness
Not included
Supplied as
Pair
Certification
CE conformity, EMC certified
Warranty
24 months

Advanced Protection Systems – Technical Chart

Protection feature
Specification
Over-voltage protection
Built-in circuit protects the LED driver from voltage surges and spikes across the 9–32V DC range
Polarity reversal protection
Protects the light if power is connected the wrong way round during installation
Short circuit protection
Automatically limits or cuts the current if a short circuit occurs, protecting the light's driver, your wiring and your vehicle's electrics from damage
Vibration resistance
Rated vibration resistant; ADC12 die-cast aluminium housing with stainless steel bracket for off-road, agricultural and commercial use
Thermal management
ADC12 die-cast aluminium housing acts as a heat sink; rated for continuous operation from -40°C to +85°C [confirm thermal derating / shutdown points with supplier]
Military-grade breather valve
IP68-rated breather equalises internal pressure to prevent condensation while keeping the seal intact
Sealing method
Integrated moulded lens and seal ring with plasma dispensing, preventing dust from building up at the edges
Waterproof certification
IP68 and IP69K (dust-tight, submersion and high-pressure, high-temperature water jets)
Connector
3-pin DT connector; weatherproof, locking and vibration-secure
Recommended wiring harness
Not included. Use a relay-switched harness with an inline fuse and suitably rated cable: pair draw is about 11–12A at 12V (about 6A at 24V) at full load [confirm gauge and fuse rating before publishing]

Professional Applications

The Focus FZ-10 is designed for people who rely on their lights, not just for the look.

  • Off-road and 4x4 expeditions: forest tracks, green lanes and remote routes where long reach and low glare matter

  • Agriculture: tractors, combines and harvest work on 12V and 24V machinery

  • Commercial and fleet vehicles: vans, HGVs and utility vehicles that run in poor light

  • Emergency and rescue support: rural, mountain and search operations that need reach and dependable sealing

  • Pickups, camper vans and overlanding builds: compact 9-inch size for bumpers, bull bars and roof mounts

  • Trades and site vehicles: reliable work lighting in mud, dust and wet conditions

About SpectrumTek

SpectrumTek is a UK-based supplier of LED vehicle lighting and control systems for the UK and Europe. We publish actual measured output and clear specifications, so you can compare lights honestly. Every product page lists what is and isn't in the box, and our team can help with fitment and wiring advice before you buy.


All SpectrumTek Focus FZ-10 lights come with a 24-month warranty and UK-based support.

Why Drivers Choose the Focus FZ-10

  • Reach without the glare: the anti-glare lamp cup throws light 680m ahead on high beam (470m on low) to 1 lux, while reducing glare for you and other drivers

  • Honest, measured output: 18,240 actual lumens on high beam and 8,640 on low beam per pair, so the figures you read are the ones to compare

  • Sealed for real conditions: IP68/IP69K protection keeps out dust, mud, immersion and high-pressure washdown

  • Built for 12V and 24V: 9–32V DC input suits cars, 4x4s, trucks and agricultural vehicles

  • Two years of cover: every pair comes with a 24-month warranty and UK-based support

Checks Before Publishing

  • Short circuit protection: your supplier data doesn't list it, so confirm it is built in before publishing

  • Thermal management: confirm the derating and shutdown points, or remove the figures

  • Warranty: make sure 24 months matches your warranty policy page

  • E-Mark: the data lists CE conformity and EMC certification, so don't copy E-Mark claims from the FZ-9 page, and confirm you hold the EMC test report

  • Chip count: six 20W chips per light is 240W per pair, but the listed LED power is 120W, so confirm the chips are driven below their rating before publishing

  • Harness advice: have the cable gauge and fuse rating checked (about 11–12A pair at 12V)

  • Model name and size: "FZ-10" on a 9-inch light may confuse buyers next to the FZ-9, so make the size clear in the title

  • Reviews: this light has none yet, so don't reuse the FZ-9 reviews

  • UK legality note: consider a line that auxiliary driving lights should be used in line with UK lighting regulations

bottom of page